nick/overland-controller
1
0
Fork 0
Code Issues Pull Requests Actions Packages Projects Releases Wiki Activity

firmware: use verified sensor settings

Browse Source
This commit is contained in:
nick
2026-07-17 02:51:40 -06:00
parent d5578ce796
commit dc7a7223fb
6 changed files with 17 additions and 73 deletions
Download Patch File Download Diff File Expand all files Collapse all files
firmware/xiao-esp32c6-sensor-node/README.md
+2 -2
View File
@@ -9,9 +9,9 @@ This Arduino sketch reads a BNO086 IMU and MAX-M10S GPS and publishes versioned,
| GPS TX to XIAO RX | D9 |
| GPS RX from XIAO TX | D10 |
Power both sensors from 3.3V with shared ground. Required Arduino libraries are Adafruit BNO08x, TinyGPSPlus, and ArduinoJson 6.x. Enable **USB CDC On Boot** for diagnostics. GPS uses hardware UART0 and RS485 uses hardware UART1. Startup probes 9600, 38400, 115200, and 4800 baud and reports the first rate producing checksum-valid NMEA.
Power both sensors from 3.3V with shared ground. Required Arduino libraries are Adafruit BNO08x, TinyGPSPlus, and ArduinoJson 6.x. Enable **USB CDC On Boot** for diagnostics. GPS uses hardware UART0 at the verified 38400 baud; RS485 uses hardware UART1.
At startup the firmware scans D7/D8 and accepts either valid BNO08x address, `0x4A` or `0x4B`. If neither appears in the scan, verify 3.3V/GND, swap-check SDA and SCL, and confirm the breakout's PS0/PS1 jumpers are configured for I2C.
The BNO086 uses the verified `0x4B` I2C address on D7/D8. If initialization fails, verify 3.3V/GND, SDA/SCL wiring, and the breakout's PS0/PS1 configuration.
The node sends `sensor_status` at 115200 baud every 200 ms. See `docs/SENSOR_NODE_PROTOCOL.md`. The initial firmware is transmit-only; add a dashboard receiver after bench-testing the node, RS485 polarity, and sensor axes.